Auto Stairwell problem

[freebird_wr]

Hello,

I have crept upon a problem that I can't figure out. I have a set of stairs on the first floor that were extended to the second floor without a problem. Now, when I select "Auto Stairwell" for those stairs, I get an info pop-up that says "Cannot find the floor above the stairs in which to place the stairwell." Is this something that someone has run into and has a solution? Thanks.

Scott

[louis]

Did you already make an open below room above?

[coxy76]

I usually get this error when the room above is open check your walls to make sure they are all connected

[Allen42acj]

Is there a floor above or the Attic?

Attic = either make a new floor or use the platform hole to make the opening.

[freebird_wr]

That was it. I had made some wall changes and the room designation was no longer "Open Below". Thanks.

[louis]

Glad I could help.