Anyone Have This?

[gpickren]

I have been seeing this in every plan, even the simple box attached. Anyone else have this?

[Dan Park]

That's really odd, I've never seen that before. Can you post this plan so we can test?

Thanks,

[Jim Allen]

I've never seen anything like that on my plans

[dshall]

that might be an invisible wall or an attic wall left over from the previous plans if you had copy/saved from a previous plan (on the floor above)

[ebdesign]

gpickren,
Looks like where some walls used to be. Try building floors & ceilings.
Just a guess.
Jim

[gpickren]

Here it is again. These are all new plans from scratch and this one does it again with nothing but four walls and an autogenerated hip roof. It does it every time.

[ebdesign]

gpickren,
They're retained attic walls. Check your profile plan attic floor.
Jim

[gpickren]

Bingo! That's it. The attic layer was turned off.

[Jim Allen]

Good call ebdesign,

gpickren, why does turning the attic layer on fix it?!!!!

[dshall]

It does not fix it. It simply shows left over attic walls that should be deleted. Maybe on the previous plans the ceiling was set at 96" and the new plan the clg is set at 97" therefore the attic walls are set lower and show thru?

[gpickren]

It does not fix it. It simply shows left over attic walls that should be deleted. Maybe on the previous plans the ceiling was set at 96" and the new plan the clg is set at 97" therefore the attic walls are set lower and show thru?

What he said. I often turn off the attic wall layer so they don't confuse the floor plan, however, they apparently were not turned off in the camera view layerset. This came about as I switched to V1.4 from V10.8. With V10 the layerset didn't change with the camera.

Now if I could only get rid of the occasional bleeding through of the foundation slab showing through the finished floor.

Thanks for the help.

[Jim Allen]

So, to permanently fix this, he has open up a new template, switch on the attic, delete them then save the template as the new default?

[gpickren]

So, to permanently fix this, he has open up a new template, switch on the attic, delete them then save the template as the new default?

Yes, that is what I did.

One thing I still don't understand though is why the attic walls were not deleted when I used the Rebuild Roofs and Walls to autogenerate the roof. Maybe I had created some manual attic walls. I don't remember what plan was used to create this template.

[Jim Allen]

I feel so proud of myself for figuring that out! Thanks for the confirmation LOL!

[ebdesign]

The attic walls were "retained". That's why they didn't "disappear" after rebuilding floors & ceilings.
Jim