Settings that need faster access

[WendyWelton]

For example multiple copy was greatly enhanced in X1 yet I rarely see any posts on it's use. I suspect this is due to it's lack of use rather than it being perfect and not requiring any improvement.

Yes - love it, use it all the time - it's my "offset" command.

But - here's some feedback. It's way way way too easy to go crooked when I most often want to be at 0 or 90 degrees. I would like a way to have Multiple Copies "included angles" be only 0 and 90, perhaps as a toggle.

I'll be using it in detailing, to copy and offset a line 3/4" of an inch - if I don't slow down (slowing down is a bad thing - by definition, means adding time) and zoom in, I'll end up crooked, and therefore not the 3/4" I want.