Results 1 to 6 of 6
Hybrid View
-
06-19-2002, 07:30 AM #1
Daniel,
Place the 3 doorways in your plan and set their size and position. You will end up with a small wall segment between each doorway. I do not know of a way to eliminate the wall segment. However, if your columns are large enough in diameter they will wrap around the wall segment to hide it. You can easily drag your columns into position by using Control Drag. You can also use the “Suppress Casing” check box on the Door dbx – Frame & Trim tab if you do not want any trim. . Hope this answers your question and welcome to Chief Talk.
Regards…Bob