Results 1 to 4 of 4
Thread: Auto Stairwell
-
02-26-2008, 11:27 AM #1Registered User Promoted
- Join Date
- Jan 2008
- Posts
- 15
Auto Stairwell
I put in a staircase from a basement to the first floor then I used the Auto Stairwell button to have it complete the railing and balusters on the first floor. After I did this, I lost all the flooring on my first floor. When looking in a render camera view I can see into the basement...why is it doing this and how can I fix it? thanks for your help!
Lori
Kustom Floor Designs
Interior Designer
Kansas
-
02-26-2008, 01:48 PM #2
Lori,
You probably have some of your walls not connected properly. If you post the plan or email it, I'll take a look at it.Allen Brown
Indy Blueprints
Residential & Commercial Designs & Drafting Service
V8-X4, Specializing in Plan Completion, Problem solving, & Chief Architect Training.
Free Chief Architect Training Videos:
www.IndyBlueprints.com
Need help on a plan? Or 1 on 1 instruction? Email or call.
www.UBuildItIndy.com
-
02-26-2008, 01:55 PM #3Registered User Promoted
- Join Date
- Jan 2008
- Posts
- 15
Allen,
Thanks for the offer but I actually got it figured out! Somehow when I built the stairway and did the auto Stairwell it turned the floor off for the whole house. So all I had to do was select each room again and make sure there was a floor in the room. Again thank you for your offer!Lori
Kustom Floor Designs
Interior Designer
Kansas
-
02-26-2008, 01:56 PM #4
Glad you got it!
Allen Brown
Indy Blueprints
Residential & Commercial Designs & Drafting Service
V8-X4, Specializing in Plan Completion, Problem solving, & Chief Architect Training.
Free Chief Architect Training Videos:
www.IndyBlueprints.com
Need help on a plan? Or 1 on 1 instruction? Email or call.
www.UBuildItIndy.com