Walls and CAD Lines Stretch

[BLayman]

Is anyone else having a problem with X1.4 where both ends of a wall or CAD line move at the same time.

I just started a new plan in x1.4 (first one with the upgrade) and several walls were longer than needed.
As I shortened drew the one end back I saw the other also retreating.
Same thing happened with a CAD line.

I'm not sure if it is setting I've messed up or do I need to send it to Tech Support.

Thanks in advance.

Bill

[HumbleChief]

Bill,

You most certainly have the concentric edit behaviors button pressed. Try a different one of these buttons. I've done that a thousand times.
You probably have this one pressed.

Try this one.

[BLayman]

Thanks Larry that fixed it. Don't know how it was changed from the default.

Bill

[mcrouse10]

having same issue, however concentric is never selected. the defaults are selected in both edit behavior dropdown, and preference settings. anu suggestions?

[lbuttery]

check your settings for "start center end" in the dbx

Lew