Results 1 to 4 of 4
Thread: reflect plan
-
02-02-2008, 12:35 PM #1Registered User Promoted
- Join Date
- Feb 2006
- Location
- Rural Northern New Mexico
- Posts
- 92
reflect plan
Hallo Chieftains,
I wish to copy and reflect horizontally and vertically my floor plan for a
2 unit condo. I shift selected the entire plan and went to transform but
it only grabs my fixtures and roof plane, not walls etc. I must be doing something wrong. Working w/ Ver. 10.o8a.
Tresa from NM
-
02-02-2008, 12:48 PM #2
Use the Edit tool.
Make sure you select all floors...then shift select the entire plan as you were doing before.
Now you can transform~replicate...and refelect.
-
02-02-2008, 01:05 PM #3Registered User Promoted
- Join Date
- Feb 2006
- Location
- Rural Northern New Mexico
- Posts
- 92
Thank you kindly VHampton. This is what I needed to do. I did copy with the copy button. A question thou about the direct Reflect catagory (horiz & vert) and the copy button are not able to choose from the transform area.
I had to change the coordinates at the bottom catagory Resize/Reflect (just switch the positive and negative) to reflect horizontally. I am wondering why the direct Horiz./Vert. Reflect is not available for me to choose?
Hope you understand my question, but I do have what I needed to do.
Thanxs Again.
Tres from NM.
-
02-02-2008, 01:36 PM #4
You're very welcome.
To answer your question...I usually make this process less complicated by doing a copy first (moved over, about 100 feet away from the original)
...and then the flipping ...and rotating.
Best, Val