X11.4 didnt do...

[05uurx]

I can see that the corner boards are NOT fixed in the latest patch

I guess i'll keep the working around this with polyline solids/slabs...

I still cant adjust the top or bottom values without the cornerboard jumping to an inside corner or dissapearing all together, only to find it later on some remote attic wall...

D'oh!

[retire45]

Have they acknowledged this problem? Knowing you have a problem is the first step to.... Does your millwork (brackets.. etc) jump up on their own? In 10.08. mine do.

[Dan Park]

Corner boards work better in 11.4. The problem is usually worst when you place them on the corner of a dormer that is aligned with an exterior wall. The best solution in this case is to place the dormer one floor up on the attic level.