Results 1 to 3 of 3
Thread: Multi-Layered Walls
Threaded View
-
08-31-1999, 04:17 PM #2Registered User Promoted
- Join Date
- Aug 1999
- Location
- Ridgway, Colorado, USA
- Posts
- 2,917
You can set your dimension to outside surface or to main layer. You can establish the main layer in the Wall Specification dbx.
You can also adjust individual dimensions by double left cliking them and draging the red dots.
If you make your 1" sheathing the main layer and set the dimensions to the main layer it will dimension both sides of the sheathing. It is probably best to keep the stud as the main layer and adjust the dimensions to the sheathing.
Hope that helps.
Larry