Results 1 to 5 of 5
Thread: X1 Double Wall Looks Weird?
-
10-09-2007, 08:44 AM #1Registered User Promoted
- Join Date
- Jul 2007
- Posts
- 223
X1 Double Wall Looks Weird?
Hi,
I'm making condos that have a double wall between units. I created a wall definition with the correct spacing, then butted 2 walls and labeled both "double wall" "frame through".
However when I draw a perpendicular wall to meet my double wall it wants to merge deep into the double wall instead of meeting it like normal. This looks really weird. (I think I attached a photo, but not sure if it's going to work?)
Do I have a double wall setting setting wrong?
Thanks very much,
Zowie
-
10-09-2007, 09:01 AM #2
Some thing is set wrong,mine snap right..
Check your wall layers,do you have the right one as the main?
Just tried changing the layer to frame to...Shut down Chief...........
Allen Colburn Jr.
Pascoag RI 02859
Residential Design Drafting/Framer
Drafter for:
http://www.artformhomeplans.com/
Chief Architect X4
-
10-09-2007, 09:43 AM #3Registered User Promoted
- Join Date
- Jul 2007
- Posts
- 223
Found the Issue: X1 Doesn't like 2 layer of Sheetrock
Seems like this is a glitch. Party wall calls for 2 layers of 5/8" gwb, this makes wall intersections look weird. Had to call one layer "air gap"
-
10-09-2007, 11:23 AM #4Special Projects Director
- Join Date
- May 2003
- Posts
- 3,113
I don't think this is a problem with X1, I suspect you have your main layer set to the sheet rock layer.
Dan Park,
Special Projects Director,
Chief Architect
-
10-09-2007, 01:11 PM #5Registered User Promoted
- Join Date
- Jul 2007
- Posts
- 223
Yup, Missed Screwed MySelf with Main Layer
Switched it in the making, duh. Thanks Dan.
Zowie