Results 1 to 2 of 2
Thread: curved wall for a large space
-
11-27-1999, 09:13 AM #1Registered User Promoted
- Join Date
- Nov 1999
- Location
- Praia, Cape Verde
- Posts
- 12
curved wall for a large space
Tim,
Yes, you have understood.
I tried with your advice points and got the problem resolved.For now I have only a minor problem which is to get the accuracy on curve radius. May be its centers are not exactly in the intersection of the cad lines cross .
I appreciate your prompt answer to my questions.
Thank you and best regards.
Pedro Gregório
Praia
Cape Verde, Islands.
------------------
-
11-27-1999, 12:55 PM #2Registered User Promoted
- Join Date
- Aug 1999
- Posts
- 6,414
Try using a smaller diameter to get the centers aligned--it's easier to see everything. You'll want them to be aligned or the roof will generate odd shaped sections.....
When you drag the walls together click "connect walls"---as long as you don't lock the centers they should connect,and align the centers---but double check your radius to make sure that it doesn't change. With a little practice this should only take you a few minutes to do.
You can't put windows and doors across the intersections, but with only two of those that really shouldn't be a problem...good luck......don't forget to hit that F3 key frequently or even save two versions of the same plan so it's easy to recover if something fouls up.......
Tim O'D
O'Donnell Construction
[This message has been edited by Tim O'Donnell (edited 27 November 1999).]