Results 1 to 7 of 7
Thread: Kitchen sink problem
Hybrid View
-
11-11-2008, 03:36 PM #1
Most of the time if you take a sink that is not cutting the hole correctly in the countertop, just open the sink (symbol), create a new cad block and assign that cad block to the symbol and then it should cut a hole in the countertop just fine. I'll note that the new cad block will look a little different from the original.
Tommy Blair
Houston, TX.
(713) 467-0579
tblair55@sbcglobal.net
Avid Chief User V8-X5
Lead Houston User's Group
HP Dv7t Quad Edition Laptop
W7 Home Premium, 64-Bit
2nd Gen. Intel Quad Core i7-2720QM 2.2 GHz (turbo boost to 3.3 GHz)
1GB Radeon HD 6770M GDDR5
8GB DDR3 System Memory, 640GB 7200rpm Hard Drive
(2) 2.0 ports, (2) 3.0 ports
17.3" Monitor (1600x900)