Results 16 to 18 of 18
Thread: Garage door outline
-
03-14-2007, 01:13 PM #16
Thanks for all your advice and trying to solve this problem.
What I was doing was trying to create a quick plan showing some Dutch doors for a horse barn.
And I didn't want to take a lot of time to search for that answer here on Chieftalk, as I think it's here as I have seen it once before.
So I just reduced a garage door down to 4' wide and changed the panel counts to make it look like a Dutch door (somewhat).
But the dashed lines inside still show, and I haven't printed the floor plan for the customer yet, so if I do I can alway create a cad detail from view and remove them, or get the proper Dutch barn door I need.
This may happen after I get a deposit check.
Below is the barn so far:Jim Rogers
Jim Rogers Timber Designs
Georgetown, MA, USA
email: jrsawmill@verizon.net
V9.54-V10.08a-VX1.5.4.17-VX2-VX3-VX4-VX5
-
03-14-2007, 01:17 PM #17
Also, Allen, I tried to use your sliding door you posted sometime ago, but the folder seemed to be empty when I and Tim O'Donnell tried it.
Did you post an empty folder or did I do something wrong?
I created those by just making a p-line solid and changing the size and position as well as texture.
Jim RogersJim Rogers
Jim Rogers Timber Designs
Georgetown, MA, USA
email: jrsawmill@verizon.net
V9.54-V10.08a-VX1.5.4.17-VX2-VX3-VX4-VX5
-
03-14-2007, 02:01 PM #18
It must have been empty then,sorry..
Let me know if this works..
I used poly solids converted to a symbol..
It might have been me doing something wrong...........
Allen Colburn Jr.
Pascoag RI 02859
Residential Design Drafting/Framer
Drafter for:
http://www.artformhomeplans.com/
Chief Architect X4