Results 1 to 3 of 3
Thread: Selection tool
-
06-18-2006, 03:35 AM #1
Selection tool
In Cross section view, I need to draw a few polyline solids. after editing a few, and down to the last one, I'm unable to select it. I was able to select it once and changed the line lengt. when I tried to change the oppisite side. I couldn't select it. Iv been tried everything. NO LAYERS ARE LOCKED.
Any ideas why I'm not able to select it ??
Thanks,
DougDoug Michel
General Contractor
Design & Build, New Jersey
Windows 7... 64 Bit,
X6 Build 16.1.1.9 X64 w/SSA
X5 Build 15.2.1.3 X64 w/SSA
X4 Build 14.3.2.2 X64 w/SSA
X3 Build 13.4.2.7 w/SSA
X2 Build 12.6.0.25 w/SSA
X1,V10,V9
Sketch Up Pro 8
AutoCad 2014
Adobe CS6 Design Premium
A Pool Cue , a Harley, a Hammer & a Camera
Good Isn't Enough... When Better is Possible.
-
06-18-2006, 05:33 AM #2
I'm sure others will have a better answer, but sometimes it is just
**** near impossible to select some things. I zoom in, I click all over, I select something near it and then use the tab or "select next" and sometimes it just won't select. Very frustrating.
Putting things nearby on separate layers and turning off those layers helps (sometimes).
It would be nice if we could draw a select marquee and be able to "select next" (or tab) rotate thru ALL objects within that marquee.
For some objects it helps to get into that "mode" by selecting the tool first. For example, click on the wall icon, and then try selecting walls and Chief makes selecting walls easier. Maybe, you were in a different "mode". I still don't have a good handle on getting and staying in the right "mode".
for some objects it seems that you have to click on an edge to select it, and for others it seems like you have to click on the object "middle".
Not really sure about all that, except it can be "fun" (read frustrating).
Lew
LewLew Buttery
Castle Golden Design - "We make dreams visible"
Lockport, NY
716-434-5051
www.castlegoldendesign.com
lbuttery at castlegoldendesign.com
CHIEF X5 (started with v9.5)
-
06-18-2006, 05:58 AM #3
Thanks Lew.......I did the undo till I got rid of it, then redrew it.......yippee...
Thankfully I had enough Undo's to get rid of it. I hate to think if I had to go back to a previous revision. Somethings ya know......
Happy Fathers Day (if it applys)
DougDoug Michel
General Contractor
Design & Build, New Jersey
Windows 7... 64 Bit,
X6 Build 16.1.1.9 X64 w/SSA
X5 Build 15.2.1.3 X64 w/SSA
X4 Build 14.3.2.2 X64 w/SSA
X3 Build 13.4.2.7 w/SSA
X2 Build 12.6.0.25 w/SSA
X1,V10,V9
Sketch Up Pro 8
AutoCad 2014
Adobe CS6 Design Premium
A Pool Cue , a Harley, a Hammer & a Camera
Good Isn't Enough... When Better is Possible.