Results 1 to 2 of 2
Thread: Open an AutoCad file
-
06-12-2006, 05:52 AM #1
Registered User Promoted
- Join Date
- Oct 2000
- Location
- Dennis, MA
- Posts
- 131
Open an AutoCad file
Quick question - is it possibe to open in chief an AutoCad file, and then manipulate it. If it is possible, I assume I would be working in the CAD mode, which is fine ... but can it be done? If an AutoCad user were to send me a file, what form should I ask for it in? Also, any special suggestions?
Thanks,
Skip.
-
06-12-2006, 07:04 AM #2
El' Senior Member
- Join Date
- Dec 2001
- Location
- U.S.A - Central Pennsylvania
- Posts
- 485
Yes you can change it in Chief 9.5 or less, but make sure it is 2002 or 2000 DWG format.
Chief does not support 2004 DWG yet.
Chief 10.0 will support 2004/2005 DWGLast edited by Rickt1962; 06-12-2006 at 07:08 AM.
You can Find me on http://www.facebook.com/RickThomas100
Thank GOD for Avatars ! So ugly people can hide behind them ! LOL
Computer User since Atari 400
AutoCad 9.0 to 2012 till Chief Came along.
Chief User Since Version 4.0
Building New Homes for 35 years.
Don't let anybody fool you ! A home builder with CAD under his belt that actually uses a hammer and computer will run circles around the Desk jockey's playing with their mouse.
Reply With Quote
