Results 1 to 4 of 4
Thread: Scaled elevations
-
06-05-2001, 08:50 PM #1Member
- Join Date
- May 2001
- Location
- Kalamazoo, MI
- Posts
- 40
Scaled elevations
In my manual I read where you cannot scale your elevation views (3Dviews) for a layout in a border drawing for blueprints. Is this correct or is there a workaround?
-
06-06-2001, 03:53 AM #2
What that entry in the manual means is that there is no "entry or check box" dialogue to automatically scale an isometric view. By using common sense and a "known" dimension one can scale a 3-D with reasonable relational accuracy.
------------------
David J. Potter
Chief Architect™Consultant, Beta Tester, Designer
1801 Wells Branch Parkway #2013
Austin, Texas 78728
dpotter1@austin.rr.com
512-251-3982
305-425-5794 FAX http://members.spree.com/djpotter
-
06-06-2001, 11:03 AM #3Member
- Join Date
- May 2001
- Location
- Kalamazoo, MI
- Posts
- 40
David- To be more specific, if I go to camera view, front elevation, and save this view to a layout page, can I print the view in 1/4" or 1/8" scale? eg. Front, rear, and sides on one page. Dan
-
06-06-2001, 02:22 PM #4
Read chapter 37 "Layout Facility" ("Rescaling Views" Section) in your user manual and also Chapter 36 "Printing and Plotting" ie. the "Printing to Scale" section.
------------------
David J. Potter
Chief Architect™Consultant, Beta Tester, Designer
1801 Wells Branch Parkway #2013
Austin, Texas 78728
dpotter1@austin.rr.com
512-251-3982
305-425-5794 FAX http://members.spree.com/djpotter