Results 1 to 6 of 6
Thread: Fascia problem
-
10-28-2005, 08:03 PM #1Gordon B.
- Join Date
- Oct 2005
- Posts
- 32
Fascia problem
I edited my roof planes in order to have my trusses created correctly, so I have one roof being framed on top of the other in a "California valley" style. Is there any way to remove the fascia from this one section? It is sticking down through my ceiling.
Gordon B.
CA 10.08
-
10-28-2005, 08:04 PM #2Gordon B.
- Join Date
- Oct 2005
- Posts
- 32
From inside:
Gordon B.
CA 10.08
-
10-29-2005, 01:07 AM #3Chief user since v-4
- Join Date
- Feb 2001
- Location
- Salem CT
- Posts
- 179
I think the simplest solution to this particular problem is to delete the surfsce in the 3d view. It should not generate again until you rebuild fascias. Is it possible to pull that roof edge back just enough to eliminate the problem? Bob
Robert Roraback
Roraback Building & Design LLC
729 West Road
Salem CT 06420
-
10-29-2005, 03:44 AM #4Registered User Promoted
- Join Date
- Nov 2004
- Posts
- 171
In plan view, select your roof plane, double-click the break line tool, and.......
- Lane
-
10-29-2005, 05:19 AM #5Gordon B.
- Join Date
- Oct 2005
- Posts
- 32
Thanks Lane, but my roof is already pulled back up to the valley line. Actually, I went back to the Training Videos last night and learned about "truss bases". I think that might be the way, but I haven't had time to try it yet.
Gordon B.
CA 10.08
-
10-29-2005, 06:03 AM #6Registered User Promoted
- Join Date
- Aug 1999
- Posts
- 6,414
Re: Fascia problem
Originally posted by Clicker
I edited my roof planes in order to have my trusses created correctly, so I have one roof being framed on top of the other in a "California valley" style. Is there any way to remove the fascia from this one section? It is sticking down through my ceiling.