Results 1 to 4 of 4
Thread: Walls and roofs not behaving
-
04-04-2005, 11:35 AM #1
Walls and roofs not behaving
Hey all,
I'm using 10.02a and coming up with the following picture. The model was created in 9.54 and I'm importing into 10. The two walls showing above the dormer roof are set as "Roof cuts wall at bottom" because of porch roof below. Unchecking this option makes the wall not go above the dormer roof, but it also does not go up to the dormer roof. Didn't have these problems in 9.54. Any suggestions?Last edited by Tim Schrock; 03-31-2006 at 05:30 AM.
Tim Schrock
Design Build Solutions, LLC.
I enjoy working in Chief Architect. Made the switch to X5 and am enjoying the upgrades. Home-brewed computer...things are running swell!
-
04-06-2005, 06:34 AM #2
Anyone? Dermot?
Tim Schrock
Design Build Solutions, LLC.
I enjoy working in Chief Architect. Made the switch to X5 and am enjoying the upgrades. Home-brewed computer...things are running swell!
-
04-06-2005, 10:30 AM #3
If you have a plan that works correctly in V9.54 and does not work correctly in 10.02a, then please send the plan to tech support so that we can take a look at it.
Dermot Dempsey
Principal Software Engineer
Chief Architect, Inc.
http://www.ChiefArchitect.com
http://www.HomeDesignerSoftware.com
-
04-06-2005, 01:29 PM #4
Can you edit the walls in a cross sectional view? I would grab the top plates and pull them down to where you want them. They should stay put after that.
FYI...10.03 is out for downloading. It's behaving very very well too.