Results 1 to 4 of 4
Thread: 1/2 Height walls
-
04-05-2005, 08:21 PM #1Ancient Junior Member
- Join Date
- Jun 2004
- Location
- Hibiscus Coast - Auckland - NZ
- Posts
- 161
1/2 Height walls
V10.2a
I've been trying to put a 1/2 height (900mm) wall under a bench & butt it into a full height wall. Because the walls are of the same type it reverted to a full height. I then made a new wall of the same definitions but gave it a new name & it worked, except when I do a render camera view it shows a shadow along the ceiling and the Full height wall has only one layer of wall lining and no end lining which it has if the 2 walls aren't connected. As usual comments will be greatfully accepted.
Thanks,
Max Cutts
-
04-05-2005, 09:36 PM #2Member-Cliff Cain
- Join Date
- Oct 2004
- Location
- Denton, TX
- Posts
- 4,311
Max, I may not understand your problem correctly, but you can make your half wall a solid railing and change your materials to match the full height wall.
Cliff
-
04-06-2005, 02:43 AM #3Ancient Junior Member
- Join Date
- Jun 2004
- Location
- Hibiscus Coast - Auckland - NZ
- Posts
- 161
Now that's a good idea, Cliff. I'll try that. I noted, in the manual, that hand rails in stepped floors & ceilings work in creating part walls but never thought of using it that way. I'll let you know what happens.
Thanks for that.
Max
-
04-06-2005, 05:30 AM #4Member-Cliff Cain
- Join Date
- Oct 2004
- Location
- Denton, TX
- Posts
- 4,311
You're welcome. Hope it works for you.
Cliff