Results 1 to 3 of 3
-
03-01-2005, 11:55 AM #1
"add Lights" fixture will not move any help
I used the add light feature in v10 and created a point spource on my plan. when I try to right click or select to move or adjust, it will not select! I have to undo or exit w/o saving to get rid of it. what gives?- i checked the layers and there not locked. can anyone shed some light on this?- pun intended
thanks
Sal
-
03-01-2005, 03:22 PM #2
The good news is that you can select them. The bad news is that you have to be about 12 pixels away from the very center of the light to get it. It actually helps to zoom way out in this case.
This is a bug. Did you report it to tech support? Actually, I have already made sure this problem was reported but I have to keep reminding people to report any problems so that we can be sure people will.Dermot Dempsey
Principal Software Engineer
Chief Architect, Inc.
http://www.ChiefArchitect.com
http://www.HomeDesignerSoftware.com
-
03-01-2005, 03:51 PM #3Just Some Guy
- Join Date
- Sep 2001
- Location
- Smith Mountain Lake, Virginia
- Posts
- 717
Hi
I was unable to duplicate the problem under V10 with the first update.Regards, Frederick C. Wilt (Began with v9, now using X6 aka v16)