Results 1 to 3 of 3
Thread: Un-Hatch a wall?
-
09-22-2005, 03:10 PM #1
Un-Hatch a wall?
I am using V10.06. I cannot figure out how to unhatch an individual wall. Any ideas?
Thanks,
AllenAllen Brown
Indy Blueprints
Residential & Commercial Designs & Drafting Service
V8-X4, Specializing in Plan Completion, Problem solving, & Chief Architect Training.
Free Chief Architect Training Videos:
www.IndyBlueprints.com
Need help on a plan? Or 1 on 1 instruction? Email or call.
www.UBuildItIndy.com
-
09-22-2005, 03:14 PM #2
If you used the hatching tool, then select the hatching tool again, and left click on the wall and it will select the hatching, not the wall, and hit delete.
If the hatching is in the wall definition, you will need to adjust the definition. If the wall is used in several places and you want the other walls to stay hatched, then copy the wall, give it a new name and take the hatching off.
Hope that helps.
-
09-22-2005, 03:18 PM #3
Worked great! I was doing that, but not realizing it was selecting the hatching.
Thanks,
AllenAllen Brown
Indy Blueprints
Residential & Commercial Designs & Drafting Service
V8-X4, Specializing in Plan Completion, Problem solving, & Chief Architect Training.
Free Chief Architect Training Videos:
www.IndyBlueprints.com
Need help on a plan? Or 1 on 1 instruction? Email or call.
www.UBuildItIndy.com