Results 1 to 5 of 5
Thread: Back clipping
-
01-26-2005, 05:08 PM #1Registered User Promoted
- Join Date
- Nov 2003
- Location
- Ft. Collins, Colorado
- Posts
- 109
Back clipping
Hey folks,
Is there a way to change the minimum length from start to stop for a cross section camera with back-clipping so I can get a small sliver of a section view?
Glenn
-
01-26-2005, 07:52 PM #2
After you draw the camera, go back to plan view (while it is still open) and select it and open the dbx (not activate) and type in a smaller number...I've found 3 works well (sometimes smaller numbers don't work well). Then make sure to click Save.
HTH
-
01-26-2005, 08:36 PM #3
The length of the backclipping is controlled by the length of the line you draw when drawing the camera.
It is all explained very well in the manual or help file.Glenn
Chief X5
www.glennwoodward.com.au
Windows 7 - Home Premium
Intel i7-920
Gigabyte GA-EX58-UD3R
6 Gb DDR3 1600MHz
EVGA GTX285 1GbDDR3
1TB Sata HD
-
01-26-2005, 09:02 PM #4
Thanks for clarifying Glenn...I assumed that information had been considered and an even smaller section was wanted, but glad you pointed it out...
-
01-27-2005, 06:59 AM #5Registered User Promoted
- Join Date
- Nov 2003
- Location
- Ft. Collins, Colorado
- Posts
- 109
Thanks for your responses. Thats just what I was looking for Ben! You just saved me alot of work. Thanks again,
Glenn