Printable View
I keep having this issue and I can not figure this one out. I have a two story part of the house, the bottom is stone/brick and above is siding. The roof is around this two story section and will not click to the siding, it clicks to the stone so my elevation shows a gap because it will not cover the stone/brick wall.
Any insight would be appreciated!
I have had this problem, try manually pulling the roof plane up against the top wall in plan view. Sometimes it works for me, other times it doesn't. :confused:
I'm not sure if there's a technical reason, perhaps to do with the actual roof framing underneath. Hopefully someone better versed in Chief logic than myself can provide an answer. :p