Half-Door Problem

I have this problem of inserting a half-door in a normal sized door way with a round arch top. Any ideas people?

I'm not sure what you are asking.

I mean the half door like the one in the attached picture. I've not seen any tools in CA for half doors, how can i make it manually?

Quote:

---

Originally Posted by Alexis

I have this problem of inserting a half-door in a normal sized door way with a round arch top. Any ideas people?

---

I could of sworn there was one in the library but I can't find it.

David Michael posted a dutch door symbol. Both closed & open.

George

Try double stacking two doors and adjusting size, etc.

Quote:

---

Originally Posted by gteacher

Try double stacking two doors and adjusting size, etc.

---

I tried that, I believe one issue to be if you oen both doors you will see a sill half way up.

Try removing the sill from the upper door-- unless I misunderstood?

Gerry,

Where is your casing?

You have to suppress casing also - replace with molding polyline

This can be done with a custom door symbol. It's a little tricky to get exactly right but it can be done. One simple option is to just create a couple of simple symbols or blocks and place them in an opening.

I prefer the custom symbol.

Quote:

---

Originally Posted by Alexis

I have this problem of inserting a half-door in a normal sized door way with a round arch top. Any ideas people?

---

One doorway with casing, “upper” and “lower” door without casing, and a lot of fiddling around... :)

Thanx dshall, gteacher, Joe Carrick, for the help. Atleast i have got a couple of ways of accomplishing the task. Lol on alexsl's "fiddling around" will try that too. Thanx again.