I am creating my first room in CA (X6) and it's a doozy. The two side walls are 44" high vaulting to 149" . How do I set this up in CA? Thank you!
I am creating my first room in CA (X6) and it's a doozy. The two side walls are 44" high vaulting to 149" . How do I set this up in CA? Thank you!
Use ceiling planes and watch some video.
tell us more about the room
This sounds like a 2nd story room. For your vaulted ceiling, you will need to uncheck the ceiling for the room (structure tab) and then build the ceiling planes manually as suggested. If the ceiling is "cathedral", the ceiling pitch should match the roof pitch. If it is "vaulted", then your ceiling pitch "might" be about 1/2 of the roof pitch depending on your design and how the roof/ceiling will be framed/built. Make sure to check out how/where your manual ceiling planes bear on the walls using the back-clipped camera tool ... sometimes I end up moving these bearing conditions/locations depending on how Chief builds them.
I agree with the advice to watch as many videos as you can find on the subject. A good grasp of how Chief functions, especially regarding roof and ceiling planes, is very important so doing a little reading in Help (F1) can be helpful.
Welcome to the forum.