I have need for a fire escape symbol. I searched the threads but found none.
This would be from a second story only.
If have one or know where to get one I would appreciate a lead.
Thanks,
Paul
Printable View
I have need for a fire escape symbol. I searched the threads but found none.
This would be from a second story only.
If have one or know where to get one I would appreciate a lead.
Thanks,
Paul
I wouldn't think it would be that hard to make..
I have seen one some place...Did you look in the CA library?
I searched the library first because I thought I had one but could not find while searching "Fire Escape".
Making one was some what none successfull. Got the steps ok but did not get the railing or the open metal rod steps or open metal rod landings so I I thought I would give this forum a try.
Pul
Hi Paul
I looked,no luck.
I used a spiral stair and a deck..
Can you post a picture?:confused:
Allen I posted a photo under another thread.
http://www.chieftalk.com/showthread.php?t=23704
Paul
That looks doable..
There is a balcony on Accustains site.(not the right spelling)That can be edited..:)
Maybe If I think of it tomorrow..
This was a pain..
If you just use stairs you can get the open treads..
I think I posted one before in "one symbol a day"But took it off because it came from a site..Can not find it,but maybe some else has it..:)
:D Just had to check out my closet...:eek:
I can let you have this one if it works..
You know, that's the best I have seen so far.
Maybe we could turn the steps around like original an fill in the opening and we got it. If not it will have to work.
Yes, I would like a copy if you please.
Thank you,
Paul
Here you go in obj format
I started playing around with the symbol allen posted, along with your picture, and here is the result.
It's a .dwg .... I haven't imported it into chief yet.
Thanks you very much. I will give it a try but it looks eal good.
Is a 3D dwg or a dwg drawing?
Paul
It's a 3d .dwg.
I did the revising in sketchup, then exported to .dwg.
I usually have more luck with .dwg than .obj format when importing into chief
exallspaniab,
I can not open your file. It only makes a plan view with no depth.
If this is correct, then what is the next step?
P.S. could you post your name.
Paul
I got it to work in TurboCad and converted for Accutrans but had problems with it in CA freezing up..
Thought it was just me..