Thanks David...that's a good list.
Printable View
Thanks David...that's a good list.
That is a great page and I saved it to my computer for future use, but it still doesn't display correctly in CA
I changed the font from Arial to Blueprintdbt and it still didn't make a difference.
Do you know which font will display it correctly?
Isn't there a setting in DEFAULTS that will have the system generate a 'tilde' when the measurement is less than a prescribed value?
I thought I saw that in there. It shows a 'tilde'. I'll go try it and come back.
Wait a sec
Not sure this is what you wanted but Chief has this built in. If there is a measurement less than 1 siteenth of an inch you can set the Default Dimension controls to display a tilde before the numerics. A screen shot is below.