Metric Plans? I can't find 'em.

The subject really says it all. I have just started using this product i.e two hours ago and although I can find the dimension defualts and have checked metric (having unchecked all other boxes) I can't seem to find the Metric Plans window that the manual and help refer too.

Frankly, I'm going nuts!!

If anyone could help I would be eternally grateful and will happily stand anyone a pint ( not everything is metric over here) should they happen to find themselves in Edinburgh.

Cheers

go to file>close all, then again go to file>change units and check the metric button...once you have done this, Chief will stay in the metric mode until you chage it back or open a plan that was drawn in imperial...

Jobs a good 'un.

Cheers Tim