i WANT THE ANGLE OF THE WALL BE 15 DEGREES HOW OR CAN CHIEF DO THIS .?????
I HAVE NOT SEEN ANYTHING IN THE MANUAL ABOUT IT OR MAYBE I HAVE NOT LOOKED UP THE RIGHT THING ......
THANKS CLYDE
Printable View
i WANT THE ANGLE OF THE WALL BE 15 DEGREES HOW OR CAN CHIEF DO THIS .?????
I HAVE NOT SEEN ANYTHING IN THE MANUAL ABOUT IT OR MAYBE I HAVE NOT LOOKED UP THE RIGHT THING ......
THANKS CLYDE
Clyde,
You can't do tis with a wall.
You will need to use something like a roof plane, sloped soffiit, polyline slab, etc.
of a normal wall ?
what about construction drawings
thanks clyde
i poste a plan a while back done in v7..check this thread
http://www.chiefarchitect.com/chieft...&threadid=3029
there are alot of times i want to design a hose with sloped walls, and i hope chief can do it on a easy way in chief 10...
thanks!
but im very pleased with chief!
may be we should put some heat on them ?
Yes, i think so!:)
there should also been some new option on the roof, wich you can place different 3d(object) shingels on it! in the 3d view the roof gets very flat and boring! agree?
have you ever put a cap on a pony wall?
I took a sill out of molding and slapped it on a pony wall and
the thing where it comes to a point on the ends its conflicting and overlapping on my doortrim? I just need it to stop like a right angle stop not to continue and also its not butting up to the wall like it should. and the molding at corners are not merging at corners....
if you build a pony wall and go to molding libary and pop a window sill no 1 is the one i used and then made it 4" high you'll see this is another problem? Chief needs to add to
if there is something you know i dn't please let me in on it
thanks
clyde